PF21's 2nd Build - Pi3/Kedei/Analogs/Power+/CG-PCB

[PF21]

okay that's kind of funny that it was from your build.
good to know about the grounding.
i have my wires soldered like i showed in the picture.is there obvious reason for this not working?
could i have burned some components? i can't find any shorts/burns on the board. Sorry for the many questions. this is my first project.

A bridge at the micro USB port is very likely. Especially if you have not been cutting the pcb and did remove the USB port. The pads lift very easily and u will likely have a bridge if that has happened. The screen will be unresponsive if this has happened, as well. Fortunately, it is easy to test and fairly simple to fix, as I did.