Quick look at the inside:
[spoiler="Inside"]Main shot of the inside:
Left half holding the Pi Zero and Camble's safe shutdown PCB with reset switch
Right half holding Helder's AIO board, the screen, wifi card, volume pot and speaker.
I wanted to put some better wires for the USB devices so i cut up an old iphone cable, as the outer casing was a bit thick i stripped it keeping the insulation part intact and twisted the wire I then used some thinner heat shrink to cover it back up:
Next I wanted to keep the battery bay as is so here is what I did to utilise the space I had:
I put a piece of 5mm fibre optic cable running from the charge LED's out through the bottom of the case:
Then finished it off by cutting up an old DVD case to create a cover:
[/spoiler]Finished pictures:
[spoiler="Finished"]
Pic of the safe shutdown script video working:
[/spoiler]Special thanks to @wermy for his great original guide, @Helder for his fantastic work on the AIO PCB, @solder for the 3D printed parts he provided for my build, @Camble for his work on the shutdown PCB, @dominator for the square screen protector and @CaptainDurden for designing me a great black and yellow cartridge label
.If I have forgotten to thank anyone then I apologise as my memory isn't that great, I welcome any comments that may make my V2 build better
Cheers
John
