Kubino's GBZ - WIP

[kubino]

thanks to this forum I also decided to make my 1st simple GBZ. The goals are:

• clean and simple build, most done by CNC routing and 3d printing
• L1 and L2 on back with custom PCB and 3d printed buttons
• redesign HoolyHoo's bracket to mach my case
• put pi0 to cartridge case for easy SD access
• use GPIO pins instead of arduino/teensy

here is the build progress:

CNC in progressShow

P_20170509_164005.jpg (1.05 MiB) Viewed 7237 times

Final resultShow

P_20170512_105924_HDR.jpg (791.35 KiB) Viewed 7237 times

I was the "lucky one" and got big LCD board with button board. Decided to keep it buttons for future use:

Big board in screen bracketShow

P_20170512_110101_HDR.jpg (1.1 MiB) Viewed 7237 times

modified button board :

Button BoardShow

P_20170512_185346.jpg (1.07 MiB) Viewed 7202 times

P_20170512_185414_HDR.jpg (1.39 MiB) Viewed 7202 times

Please ignore my crappy soldering, also caused by my wrong design of ground pads

seems like D-PAD can be used original, rest buttons will be redesigned

Mount button boardShow

P_20170512_185520_HDR.jpg (1.12 MiB) Viewed 7202 times

Test fit to see how it might looks at the end

Test fitShow

P_20170512_112402_HDR.jpg (1.48 MiB) Viewed 7237 times

[rodocop]

Looking good.

[hueblo]

pic or sketch of the 3D printed buttons? @kubino

[kubino]

pic or sketch of the 3D printed buttons? @kubino

you can find it on thingiverse : http://www.thingiverse.com/thing:1924850

[hueblo]

pic or sketch of the 3D printed buttons? @kubino

you can find it on thingiverse : http://www.thingiverse.com/thing:1924850

Nice! I would love to see how they look installed, if possible.

[kubino]

pic or sketch of the 3D printed buttons? @kubino

you can find it on thingiverse : http://www.thingiverse.com/thing:1924850

Nice! I would love to see how they look installed, if possible.

next week I will continue with this build I'll post more photos later.