-Much thinner (~1cm)
-Much lighter
-Fits Pi3
-Fully printable
-80% screw joints
-2 external USBs
I designed this because the original DMG shell was just too big. I also wanted everything to go together as cleanly as possible. I've test fitted everything up to this point and am soon going to do a final, HQ 3D print. I'm only waiting on the button board at this point.
In the pics, the brackets for the speaker, amp, powerboost and charging port are hidden. They fit into the "chin" beneath the button board. I should note that this design will fit a full Pi (with ports removed). Mine's just cut because previous iterations required it.
Here are the pics (without the screen lens):
Features:
-Much thinner (~1cm)
-Much lighter
-Fits Pi3
-Fully printable
-95% screw joints
-2 external USBs
-Uses common parts
Specs:
-Pi 3
-PowerBoost 1000C
-Adafruit 2.5W audio amp
-Gearbest 3.5" composite display
-2500mAh Adafruit LiPo
I designed this because IMO, the original DMG shell was just too big. I also wanted everything to go together as cleanly as possible.
Without further delay, here are the photos (without screen lens):