Re: My first build, SAIO, 3D Printed Shell
Posted: Fri Mar 09, 2018 6:12 am
Build update:
I had some problems with the brass inserts in the screen bracket, they got ripped out.
So I changed the design and Im using brass nuts now with size M2. Works much better.
Added some stickers from YaYa, looks great!
Also I have covered all the LEDs on the board with black nail polish so they dont shine through the case, it works.
Only the status light on the top are still a little bright, but right no I have no idea how to improve this.
I have also tried to blacken the indented letters with the nail polish but it didn come out so good.
Anybody other ideas how to color the letters?
I spend alot of time for the software part, this side is finished so far. Still alot of questions though....
Next steps:
Install the Gorilla Glass
Wire the Cartreader to the SD-Reader
I had some problems with the brass inserts in the screen bracket, they got ripped out.
So I changed the design and Im using brass nuts now with size M2. Works much better.
Added some stickers from YaYa, looks great!
Also I have covered all the LEDs on the board with black nail polish so they dont shine through the case, it works.
Only the status light on the top are still a little bright, but right no I have no idea how to improve this.
I have also tried to blacken the indented letters with the nail polish but it didn come out so good.
Anybody other ideas how to color the letters?
I spend alot of time for the software part, this side is finished so far. Still alot of questions though....
Next steps:
Install the Gorilla Glass
Wire the Cartreader to the SD-Reader