This is my first build so don't mind the glue,
Some features include,
-Kite's Circuit Sword V1.1E https://github.com/kiteretro/Circuit-Sw ... inal-V1.1E
-6000mAh Lithium Ion battery (not sure battery life, so far going on about 6 hours?)
-Hoolyhoo's 3D printed Display holder https://sudomod.com/forum/viewtopic.php?t=2553
-Mounting screw standoffs took to long to arrive in the mail so just used an M2 screw and nut, heated with soldering iron and pushed in mounting holes.
-X + Y buttons
-L + R buttons
-lots of glue
FrontShow
BackShow
InsideShow
Side - USB and HDMI-miniShow
Side - SD slot, USB-C charging and mode buttonShow
Inside Front HalfShow
Inside Back halfShow
WorkingShow
Thoughts:
Fun build.
Glue, not the biggest fan of putting things in with glue because I can't go back and change it if I need too, as you can tell.
Temperature, I don't think I can squeeze a fan in there, but so far CPU temp is only getting to 60 degrees.
Joystick and buttons, would also like to add a joystick and more buttons so I can play N64 and PlayStation games. But this is great for SNES and GBA.
D-Pad and X-Y buttons, Haven't figured it out yet, but the D-Pad is sitting a little low, so makes it hard to push and it drops down if it is facing the front side downwards. If anyone has a tip for that much appreciated.
Thanks!