My 1st CSO, 2nd build
Posted: Sun Mar 24, 2019 12:11 am
Hello all,
I wanted to share my 2nd build using the Cirucit Sword with you.
My 1st one was based on AIO with completely 3D printed shell.
Now Im using:
Kites CSO Set
3rd Party Shell
Dextech Battery
Gorilla Glass Screen
2 fans
PSP Joystick
some 3D Printed Parts
and bit of epoxy for the Screen Bracket
Otherwise no use of glue.
I have taken all the 3D prints available here and optimized them to improve cable routing etc.
Took me several iterations to get the result I wanted
Compared to to others the biggest difference is that I moved the rear buttons on the side so the GBZ does not lie on them.
See the pics:
Things to do:
1. The Screen Protector seems to small for the shell. Need to find a way to close the gap with some kine of Glas glue. Any Ideas?
2. Add Glas Fibers to show the LEDs on the front of the shell.
3. Add Wireless Charging
4. Optimize Software and get emulators running better. (e.g. PSP)
I wanted to share my 2nd build using the Cirucit Sword with you.
My 1st one was based on AIO with completely 3D printed shell.
Now Im using:
Kites CSO Set
3rd Party Shell
Dextech Battery
Gorilla Glass Screen
2 fans
PSP Joystick
some 3D Printed Parts
and bit of epoxy for the Screen Bracket
Otherwise no use of glue.
I have taken all the 3D prints available here and optimized them to improve cable routing etc.
Took me several iterations to get the result I wanted
Compared to to others the biggest difference is that I moved the rear buttons on the side so the GBZ does not lie on them.
See the pics:
Things to do:
1. The Screen Protector seems to small for the shell. Need to find a way to close the gap with some kine of Glas glue. Any Ideas?
2. Add Glas Fibers to show the LEDs on the front of the shell.
3. Add Wireless Charging
4. Optimize Software and get emulators running better. (e.g. PSP)