sudomod

Standard Gameboy build with Rpi3A+ and 3.2inch SPI screen
Powerboost 1000c, Safe shutdown circuit, Usb hub, arduino micro with analog joystick,
3mm screen lens from www.deadpanrobot.co.uk



HDMI out and volume wheel


Gameboy color cartridge with accesible SD card slot and LR buttons


Top with USB port


Inside before wiring

really nice build (again)

how does the Power boost perform with the whole set up....
(any lightening bolts)

also any images/pics of the button PCB and arduino micro setup....
and how is the HDMI out done (as the port on the RPi3A+ isn't anywhere near the edge of the case)


Thank



.

VeteranGamer wrote: ↑

Sun Apr 07, 2019 6:05 am

really nice build (again)

how does the Power boost perform with the whole set up....
(any lightening bolts)

also any images/pics of the button PCB and arduino micro setup....
and how is the HDMI out done (as the port on the RPi3A+ isn't anywhere near the edge of the case)


Thank



.

Powerboost 1000c can easily handle the pi3a+ and spi screen ( backlight draws only 80mA ,rpi maxed out at 700mA when playing n64 ), arduino micro is glued to the button pcb from back side hence the cutout in back cover battery compartment, hdmi extension is made from connectors wired together.

Awesome as always!

A nice clean looking build, the 3D bracket looks slick too.

...very nice! Does it has a fan inside...? My Pi3A+ only works with fan cooling.

lightpixel wrote: ↑

Mon Apr 08, 2019 12:40 pm

...very nice! Does it has a fan inside...? My Pi3A+ only works with fan cooling.

No fan just the heatsink seems to do the job but back cover gets warm to touch

very good job...
Can you please show us some pictures from inside fully wired?

^^^ I'd love some more nudes!

Looks great . Really nice build. I haven't desoldered my A+ yet but it seems like that cart fit will be tight and require some trimming !