My Circuit sword CM3 build + SuperGameGirl

[makazatra]

Hello all!
I felt it was time after being silent on this forum to show off my builds!
On the top left we have a Circuit sword CM3 build with L1 and R1 buttons.
For thise wondering: Yes, it is totally worth it and yes, i will buy another one when the next preorder comes around!
Im still looking for a cartridge and a nice sticker to put on it. Anyone know a good adress?(EU based)
Noteworthy:

• 4000mah battery
• HDMI out
• Usb type C charging port
• Cooled by an active fan
• Original DMG01 casing (aliexpress)
• Gorillaglass screenprotector

On the right we have a SuperGameGirl with a stripped down Raspberry Pi 3B+. The case has been custom 3d printed (with the files provided for this board) on a HP 3d printer (i have not done any post processing on it).
Noteworthy:

• Custom 3d printed case (stl provided by the creator of the board)
• Beefy 6000mah battery
• L1, L2, R1, R2 buttons
• Full Raspberry Pi 3b+ board inside (stripped down to the bare board)
• Endless customization because of the 3d printed case
• Only a fraction smaller than the original Gameboy
• Because of the bigger battery it is a little bit heavier (which i like)

Gameboy Null V1 for show

IMG_20191012_142601__01.jpg (1.32 MiB) Viewed 2617 times

IMG_20191012_142534__01.jpg (1.4 MiB) Viewed 2617 times