[Help] Screen not on Wiki - ZCD630A-3.5D_V1.1

[Florian]

Hello,
I have a problem with my screen, the dirver is not on the Wiki Sudomod. This is the ZCD630A-3.5D_V1.1 driver. So I am stuck in the realization of my Game Boy Zero.
On the Wiki the variant n ° 7 is the closest one but it is not identical.

36549515_955435174629745_8344679963554742272_n.jpg (420.83 KiB) Viewed 8288 times

Here are my questions:

1 - Do you have any idea of the modification to bring to my screen to pass it in 5V?
2 - If I make a mistake in the connection (modification of variant 7 and it is not the correct change) my screen will die?

Thank you

[tinkerBOY]

It looks similar to mine. Can you send another picture so I can clearly see the chip with the red circle:

IMG_1755.JPG (518.96 KiB) Viewed 8254 times

Here's my screen board with the 5v wire directly soldered to a diode beside the XL1509 chip(5v regulator).

IMG_1754.JPG (1.97 MiB) Viewed 8254 times

[Florian]

Hello, I looked at the chip you indicated on my publication.
on the one you have designated it is mentioned:

XL1509
-5.0E1
72104

DSC00033.JPG (2.55 MiB) Viewed 8233 times

[tinkerBOY]

Most of these screens use that chip.

Here's how to directly wire the 5v wire:

IMG_1764.PNG (19.56 KiB) Viewed 8230 times

Here:

IMG_1765.JPG (2.56 MiB) Viewed 8230 times

[Florian]

The components bear the following inscriptions:

numéroté.jpg (820.74 KiB) Viewed 8230 times

1 -
XL1509
-5.0E1
72104

2 -
MK
25D403TiG

3 -
ATM 630A
G173460914

4 -
X27000

5 -
SS14

6 -
M7

7 -
7001

[tinkerBOY]

Read my previous reply above. That's where you connect the 5v, to the pin 2 of the XL1509 chip.

[Florian]

So in the end the modification must be done so, is it correct?

cablé.jpg (836.27 KiB) Viewed 8228 times

[tinkerBOY]

So in the end the modification must be done so, is it correct?
cablé.jpg

Yes that's correct.

[Florian]

I thank you for your saving response.