Circuit Sword Volume Wheel

[Defect02]

Just finished building a Circuit Sword and now I'm trying to set everything up. im trying to enable the volume wheel to work but i can't seem to figure it out im following his wiki to set it up but whenever i press "8 - Toggle Analog Volume enabled config" and exit out of the Configurator the volume wheel still doesn't work. I've tried both values of "Analog volume enabled: 0" and "Analog volume enabled: 1" neither of them seem to get the volume wheel to work any help from those of you who know what you are doing?

[kite]

Have you connected the 3 pin cable that goes between the main board and the volume board?

[Defect02]

Thanks for the reply i figured it out i had to redo the image i think i had messed it up somehow