sudomod

Hey all. As I was removing some kapton tape, I pulled off a section of trace for the start button on my Circuit Sword Lite. I’ve seen some videos for trace repair, and it seems pretty challenging for a soldering noob like me, but I don’t really have any other options. Based on the trace’s location, I’m worried the repair will impact the performance of my right button on the D-Pad.

Any thoughts or advice? I finally got my gbz built this summer, and I’m pretty crushed that I just messed it up.

Thanks.

Trace looks in tact to me. As long as the trace is in tact, I would not worry about it. If it's not in tact, then a small solder bridge will fix it.