sudomod

Hi
I recently bought a 3,5" car monitor and the pcb board looks like in the picture below. Does anyone have an ideea how to get this work on 5V? I found few posts regarding this board but is nothing 100% sure. I would appreciate your help. Thans

Here's your solution.

https://www.sudomod.com/forum/viewtopic ... 892#p44008

I have the same and it works

I've seen that post but I wasn't entirely sure about that mod. If it works fine for you then I don't see any reason not to work for me to. Thank you!

Update. It doesn't work. It seems that board doesn't work on 5v or at least nobody knows how to do it. I have no ideea how it works for you. I just bought the other version of it. Thanks!

George.p wrote: ↑

Thu Jan 25, 2018 11:11 pm

Hi
I recently bought a 3,5" car monitor and the pcb board looks like in the picture below. Does anyone have an ideea how to get this work on 5V? I found few posts regarding this board but is nothing 100% sure. I would appreciate your help. Thans

Can you post a better picture of this. I can help you. I just need to be sure

Hi. This is the board, but don't worry about it because I have Version 9 from wermy's posts. I had to buy another one. I couldn't make it work, I'm not that good in electronics and stuff, I just follow instructions on forums, but for this board I could find only one review... Thanks for your intention, I appreciate it.

This is the one that I replaced the first one with. And it works fine.

this works

Thanks. I'll save this for a future project. Appreciate your help