2.2 board and usb keyboard

[sbharri2]

I have the 2.2 all in one board and have a problem with a usb keyboard im trying to plugin. Wheneven i plug in a usb keyboard, the controller is not recoginized and also the usb keyboard does not work. When i unplug the usb keyboard, the controller resumes working. Any ideas? I have tried to plugin the keyboard to the pi’s usb and also the usbs i have connected the the 2.2 board. Same results for both.

[VeteranGamer]

I have the 2.2 all in one board and have a problem with a usb keyboard im trying to plugin. Wheneven i plug in a usb keyboard, the controller is not recoginized and also the usb keyboard does not work. When i unplug the usb keyboard, the controller resumes working. Any ideas? I have tried to plugin the keyboard to the pi’s usb and also the usbs i have connected the the 2.2 board. Same results for both.

Helder has a support section for his AIO......

please post any queries/issues there....
(but chances are they already been asked and resolved).....


https://sudomod.com/forum/viewtopic.php?f=52&t=1185


like keyboard issues...

just an example....




.

[sbharri2]

Sorry, I am new to this. But if I can't get a keyboard to plugin then how do I put in code? I've read those already and am stuck with a chicken and egg situation.

[VeteranGamer]

Sorry, I am new to this. But if I can't get a keyboard to plugin then how do I put in code? I've read those already and am stuck with a chicken and egg situation.

ahhhh.... that chicken and egg conundrum.....


you meant to do it on/via your PC.....

download & install (its completely safe, and the best to edit text document)
https://notepad-plus-plus.org/download/v7.5.6.html


put you SD Card into your PC
double click on boot, and it will open... where you'll find the config.txt and cmdline.txt


right click the config.txt and select edit with Notepad++ (add the bits you need to and save)

right click the cmdline.txt and select edit with Notepad++ (add the bits you need to and save)


voila



NB: if you actually read or looked at the support thread you might of noticed....
Helder has already provided a edited config.txt and a cmdline.txt that you could use (just replace the one you already have)



.

[sbharri2]

Thanks for the reply. That was what I did not understand.