sudomod

Hey guys need abit of advise and help if possible

I have a 'InnoLux' Ebay screen which i am having problems getting power to via the raspberry pi zero board, the screen has been tested with a direct input from a megadrive and plugged directly into a 5v supply after doing 5v mod and worked completely fine, however when it on the raspberry pi i am just gettings a black screen.

Ive tried two different wiring types, one from wermy guide and also the guide from Fleder also.

The pi itself is flashing green but not a peek out of the screen.

Any help would be great

Thank you very much

Also tried both white and yellow wires to video output with no luck

Hello, hope you figured it out already, if not try using a multimeter to see if you have a good connection to the chip you soldered onto, also don't bridge the red wire just hook straight from the chip to the pi zero. Anyways I hope this helps, please post an update, good luck.