Page 1 of 1
Kites CS cm3 psp joystick
Posted: Sun Dec 16, 2018 11:37 pm
by Defect02
All right guys so this is my first build and also first anything to do with soldering. I got down the soldering part and everything only problem is i thought i was smart with the way i was routing the wires and ended up not being able to close my gameboy up. Now the wires are too short to route them a different way. Can anyone link me to the proper 4 pin jst connector for the circuit sword? Would be much appreciated.
Re: Kites CS cm3 psp joystick
Posted: Wed Dec 19, 2018 7:37 pm
by Defect02
No help?
Re: Kites CS cm3 psp joystick
Posted: Wed Dec 19, 2018 8:18 pm
by DieselDummy
Post a photo of what you are talking about. Which way did you route the wires? Is the harness still attached to the joystick?
Re: Kites CS cm3 psp joystick
Posted: Thu Dec 20, 2018 11:07 pm
by Defect02
This is the connector I need
- 20181220_220851.jpg (6.07 MiB) Viewed 4581 times
Re: Kites CS cm3 psp joystick
Posted: Thu Dec 20, 2018 11:11 pm
by Defect02
So the wires are not connected I desoldered them, and I tried to route it through one of the holes on the kites PCB which doesn't work because the wires lift the PCB too high and doesn't allow the case to close properly I know where to route them now I just need a new connector
Re: Kites CS cm3 psp joystick
Posted: Fri Dec 21, 2018 2:31 am
by Phiro13
You can buy these on eBay or AliExpress. Just Look after jst 1.0 4pin.
Re: Kites CS cm3 psp joystick
Posted: Sat Dec 22, 2018 12:23 pm
by Defect02
Phiro13 wrote: ↑Fri Dec 21, 2018 2:31 am
You can buy these on eBay or AliExpress. Just Look after jst 1.0 4pin.
thanks man this is what I wanted to know!!!! Thanks for the help!