sudomod

Hello,

i have a little issue with my Build. On startup the message "No Gamepad detected" appears. I wired it as tinkerboy mentioned in his tutorial

https://www.tinkerboy.xyz/how-to-wire-t ... ata-cable/

One Question is D- allways a white wire?

thanks
Peter

Was it working before? Because I have already stopped making this board for quite some time already.

Iam just building it. I think i have to get another OTG-Adapter. Connected it to my pc and both red led turn on. As i understand that mean the arduino is working.

spacemishka wrote: ↑

Thu Aug 22, 2019 11:26 am

Iam just building it. I think i have to get another OTG-Adapter. Connected it to my pc and both red led turn on. As i understand that mean the arduino is working.

Yes that means it's working.

Well now, when the board is connected to the pc, the green led turns on but the reds doesn't. Furthermore the board gets not recognized.
What to do?

The pads on the pi for D+ and D- are very close together on the pi, and easy to bridge. Make sure there is no continuity between those two pads after soldering, and also make sure the pad for D- is not bridged to ground, since it is so close to that ground point right beside it.