Wiring audio, still need help :/

Throwawayallday · Post by **Throwawayallday** » Sun Dec 15, 2019 3:39 pm

I don't want to spam the board so I have edited my previous thread.

I have all my parts and I have tested my RPOw and Screen and all seem to be in working order.
I am running into a problem, I am unfamiliar with wiring...I am slowly learning by hoping from thread to thread and searching google, but I could use some help from more experienced builders as this is not my expertise and I am merely guessing

Here is my current layout

The numbers indicate the pins on the Pi, to save space instead of having more lines crossing.

I am slightly confused about how to properly wire the AMP, add-on board, the main board, and speaker together. I've tried searching the forums and google and using the discord (this forum and /r/gameboy) and either I get no information or something that helps with a different part set-up and I am honestly confused.

I am also wondering if anyone had any recommended 3D printed screen holders that would accommodate my current part set up.
SUPERMAN's response was in response to my previous parts list.

Thanks for any advice or help!

superman · Post by **superman** » Sun Dec 15, 2019 4:41 pm

Defiantly go for the pcb with the audio jack i am battling with fitting a audio jack in mine and regretting buying the one with no jack...
here are some of the 3d printed parts i did mine in pla
https://www.thingiverse.com/thing:2865730
https://www.thingiverse.com/thing:3189347
you can use the rear button bracket or the screw hole ones on the screen mount...
here is the link for the rear mount buttons https://www.ebay.com/itm/Tactile-Push-B ... 2749.l2649

superman · Post by **superman** » Sun Dec 15, 2019 4:53 pm

Also go for the gear beast screen. I bought the amazon one and have been soldering since I was 9 and it took all my skills to remove the chip. I nearly ruined it.

Throwawayallday · Post by **Throwawayallday** » Sun Dec 15, 2019 5:47 pm

superman wrote: ↑
Sun Dec 15, 2019 4:53 pm
Also go for the gear beast screen. I bought the amazon one and have been soldering since I was 9 and it took all my skills to remove the chip. I nearly ruined it.

Ha, thanks for the input. I was leaning that way regardless as it I didn't really care to dismantle anything. I went ahead and got the gearbeast one as it was on sale for only a few more hours

Althought I may regret it after more looking around as I have just found this BUNDLE
Oh! I like those molds! I haven't seen any that would allow me to just screw them into the case as of yet!

Throwawayallday · Post by **Throwawayallday** » Mon Jan 06, 2020 10:07 pm

Bump for new info

Throwawayallday · Post by **Throwawayallday** » Tue Jan 14, 2020 8:01 pm

Bump again for last time.

Wiring audio, still need help :/

Wiring audio, still need help :/

Re: First time builder (Part Check and Help)

Re: First time builder (Part Check and Help)

Re: First time builder (Part Check and Help)

Re: Updatedv3; help with pinout and printer parts

Re: Wiring audio, still need help :/

Who is online