Page 1 of 1

Teensy Help

Posted: Wed Oct 05, 2016 4:08 pm
by Deramin
Hello! I decided to go with a teensy for one of my builds cause I had the extra space and I still have no idea how to deal with gpio :P

Now I need help figuring out how to set this thing up.
I was trying to follow Wermys instructions in his part 2 guide ( but I guess I am really dumb cause I cannot figure it out.

I have my teensy wired up to a kitsch bent v2 DMG + control panel... now what .. the arduino softwhere goes on my computer? my Pi? and so on .. I know this may seem really dumb but I am still pretty new to this whole programming thing :P even if its just following instructions.

Once again thank you all for your help!

Re: Teensy Help

Posted: Thu Oct 06, 2016 6:37 pm
by Deramin
Figured it out no worries :P