Page 1 of 1
PI 3 remove component with Cutting pliers
Posted: Thu Apr 27, 2017 2:35 am
by Lololo
Re: PI 3 remove component with Cutting pliers
Posted: Thu Apr 27, 2017 7:48 am
by TheDeviantZen
Already did the same process on a Raspberry pi 2.. It's the easiest way for those who don't have proper soldering iron with sucker
Re: PI 3 remove component with Cutting pliers
Posted: Mon May 15, 2017 4:29 am
by Lololo
And now cut :
- scie.JPG (69.36 KiB) Viewed 7803 times
:
Re: PI 3 remove component with Cutting pliers
Posted: Mon May 15, 2017 5:55 am
by cpeb
braver person than me cutting the board lol
Re: PI 3 remove component with Cutting pliers
Posted: Thu Jul 20, 2017 7:30 am
by Mikethesith200
so you just solder to the pp pads on the underside then?
Re: PI 3 remove component with Cutting pliers
Posted: Thu Jul 20, 2017 7:36 am
by Eccho
Oh wow didn't know this thread existed, thanks for resurrecting it.
And yes, you can solder on the pp pads on the backside, they are still some available. Is it USB you want to connect? If so, then yes you can still connect it.
Re: PI 3 remove component with Cutting pliers
Posted: Thu Jul 20, 2017 9:00 am
by abrugsch
those camera/display ribbon connectors never come off cleanly
well maybe with a decent hot air rig
Re: PI 3 remove component with Cutting pliers
Posted: Thu Jul 20, 2017 12:54 pm
by Lololo
Yes i use pp pad...I think to make a topic when everything is finished
- 20170713_153401.jpg (3.02 MiB) Viewed 7522 times