I need a favour from someone with DSL button membranes. (anybody stocked up for a Minty Pi? ) Nothing too complicated - just the diameter of the contact pills and the distance between them, for both ABXY and the Dpad. As I've mentioned on the forum, I'm trying to design a custom PCB for my build, but I need to know contact size and spacing to do that.
Looking for DSLite membrane dimensions.
- RetroRocket
- Posts: 146
- Joined: Sun Apr 09, 2017 8:53 pm
- Location: Seattle
- Has thanked: 60 times
- Been thanked: 64 times
- Contact:
Re: Looking for DSLite membrane dimensions.
I've got you covered, note that these are taken from the PCB contact points which cover the maximum distance of the pads you show; the actual conductive pad is slightly smaller.
D-Pad:
Y Dimension: 18mm
X Dimension: 4mm
ABXY:
Y Dimension: 20mm
X Dimension: 5mm
D-Pad:
Y Dimension: 18mm
X Dimension: 4mm
ABXY:
Y Dimension: 20mm
X Dimension: 5mm
Last edited by RetroRocket on Wed Jul 05, 2017 8:48 pm, edited 1 time in total.
- RetroRocket
- Posts: 146
- Joined: Sun Apr 09, 2017 8:53 pm
- Location: Seattle
- Has thanked: 60 times
- Been thanked: 64 times
- Contact:
Re: Looking for DSLite membrane dimensions.
Edge to edge, the farthest distance of the contacts. center to center would be 14mm for the D-Pad and 15mm for ABXY
Who is online
Users browsing this forum: No registered users and 1 guest