Page 1 of 1
Looking for DSLite membrane dimensions.
Posted: Wed Jul 05, 2017 6:16 pm
by ICMF
I need a favour from someone with DSL button membranes. (anybody stocked up for a Minty Pi?
) Nothing too complicated - just the diameter of the contact pills and the distance between them, for both ABXY and the Dpad. As I've mentioned on the forum, I'm trying to design a custom PCB for my build, but I need to know contact size and spacing to do that.
Re: Looking for DSLite membrane dimensions.
Posted: Wed Jul 05, 2017 6:38 pm
by RetroRocket
I've got you covered, note that these are taken from the PCB contact points which cover the maximum distance of the pads you show; the actual conductive pad is slightly smaller.
D-Pad:
Y Dimension: 18mm
X Dimension: 4mm
ABXY:
Y Dimension: 20mm
X Dimension: 5mm
Re: Looking for DSLite membrane dimensions.
Posted: Wed Jul 05, 2017 6:49 pm
by ICMF
Awesome! Thanks!
Just to clarify, is that Y-dimension edge-to-edge, or centre-to-centre?
Re: Looking for DSLite membrane dimensions.
Posted: Wed Jul 05, 2017 8:38 pm
by RetroRocket
ICMF wrote: ↑Wed Jul 05, 2017 6:49 pm
Awesome! Thanks!
Just to clarify, is that Y-dimension edge-to-edge, or centre-to-centre?
Edge to edge, the farthest distance of the contacts. center to center would be 14mm for the D-Pad and 15mm for ABXY
Re: Looking for DSLite membrane dimensions.
Posted: Wed Jul 05, 2017 9:04 pm
by ICMF
Just making sure.
Thanks again.