CM3 IO module schematic

Hardware-related questions that don't fit into any of the specialized hardware categories go here.
Post Reply
Cyborg_delta1
Posts: 48
Joined: Fri Sep 30, 2016 12:17 am
Has thanked: 11 times
Been thanked: 6 times

CM3 IO module schematic

Post by Cyborg_delta1 » Fri Jul 14, 2017 2:43 pm

Hello all I was wondering if anyone can help me with this I am following the schematic for the power delivery on the CM3 IO board but I Am a bit stumped. There are two capacitors and two resistors with the value of NF now I gather that it means 1nF now if that is true then I am fine on the capacitors but the resistors a 1nF resistor does not exist could someone please point me in the right direction

Image

User avatar
kite
Posts: 892
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 231 times
Been thanked: 299 times
Contact:

Re: CM3 IO module schematic

Post by kite » Tue Jul 18, 2017 11:32 am

If you look on an ACTUAL CMIO you can see all those components are not soldered on.. typically they are "NP" for 'Not Populated' or "NC" for 'Not Connected' ... maybe "NF" is 'Not Found' or 'Not Fabricated/Not for Fabrication' ? Either way they are not populated on a real CMIO therefore you can ignore them

Cyborg_delta1
Posts: 48
Joined: Fri Sep 30, 2016 12:17 am
Has thanked: 11 times
Been thanked: 6 times

Re: CM3 IO module schematic

Post by Cyborg_delta1 » Thu Aug 03, 2017 12:01 am

https://youtu.be/3O8J2locx5o

That makes sense thanks kite

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest