sudomod

Hello all I was wondering if anyone can help me with this I am following the schematic for the power delivery on the CM3 IO board but I Am a bit stumped. There are two capacitors and two resistors with the value of NF now I gather that it means 1nF now if that is true then I am fine on the capacitors but the resistors a 1nF resistor does not exist could someone please point me in the right direction

If you look on an ACTUAL CMIO you can see all those components are not soldered on.. typically they are "NP" for 'Not Populated' or "NC" for 'Not Connected' ... maybe "NF" is 'Not Found' or 'Not Fabricated/Not for Fabrication' ? Either way they are not populated on a real CMIO therefore you can ignore them

https://youtu.be/3O8J2locx5o

That makes sense thanks kite