Hey guys, i recently got the http://sudomod.com/wiki/index.php?title ... te_Display and I'm having some trouble with the battery/ the input voltage. I'm using a 3.7 volt battery i picked up from a local electronics store http://www.jaycar.com.au/18650-recharge ... e/p/SB2308, though when i put power on the board using the battery it flickers and turns off and on. Though when i hook it up to a 6 volt power supply from the wall it works fine, I'm a little confused.
Any help is greatly appreciated!
Pic attached is from the wiki but is exactly the same as my board with the wire modification.
Screen voltage
- Fleder
- Posts: 849
- Joined: Thu May 05, 2016 9:04 am
- Location: Germany
- Has thanked: 183 times
- Been thanked: 258 times
Re: Screen voltage
Of course it flickers. The battery is 3.7v.
You need a step-up module or the powerboost to bring it up to 5v at least.
You need a step-up module or the powerboost to bring it up to 5v at least.
Re: Screen voltage
Ah, I derped abit, i was putting the battery straight to the screen without thinking about that.
Thank you for the helpful reply even if it was a silly question
Thank you for the helpful reply even if it was a silly question
- Fleder
- Posts: 849
- Joined: Thu May 05, 2016 9:04 am
- Location: Germany
- Has thanked: 183 times
- Been thanked: 258 times
Re: Screen voltage
There are no silly questions. We all have those blockhead moments every once in a while
Who is online
Users browsing this forum: No registered users and 1 guest