[For Sale] (READ FIRST POST!) GBZ All In One PCB (Pre Orders #3) Board version 2.0 SOLD OUT

[MichaelDP]

thank you so much for opening up the pre order again Helder.

You're a top Man!

[Helder]

thank you so much for opening up the pre order again Helder.

You're a top Man!

Sure no problem.

I too am fine.

Most of my roms will be going over wifi too

That is the reason people want wifi I assume and in my tests it went fine to transfer roms so since the green light has been given the order will go in tonight.

[Sesambrötchen]

I´m fine with 1.1, too.
If there is anything that I have to transfer via USB Flash I can wait a sec. I´m not in a Hurry

[bragdonjm]

1.1 is fine.

[Frodowills]

Any chance we can see a picture of the new board finished?

[dcex1]

Go ahead, super excited! Really appreciate all the hard work you put in!

[Frodowills]

Also, does the USB 1.1 get set on your end or is it something we have to do?

[Helder]

Any chance we can see a picture of the new board finished?

Updated the first post with actual pictures, ignore the 2 wires as that was some fix needed for these prototypes to properly work (preorder bards will be 100% ready to go with no fixes)

Also, does the USB 1.1 get set on your end or is it something we have to do?

It's something you have to do but is easy to do and I will post simple instructions when the time comes.

[Chedda]

[iSP]

Looking at the photo's, is there any way to make the 3,5mm audio jack socket more flush with the case? Now it's sort of shifted inwards.
I'm asking as my preferred headphones have a bit of a thicker plug and I'm not sure it'll fit.