[SOLD] Circuit Sword CM3 Gameboy
Posted: Mon Sep 30, 2019 1:10 am
I am selling my fully assembled Gameboy CM3. I don't use it as much as I'd like. I figured someone might as well get some use out of this rather than me keeping it. When I built it, I went with a "no glue" mindset, thus using 3D parts and strong 3M tape to keep it intact. $200 OBO shipped from California
- Dark Grey DMG shell with light grey buttons
- Kites Circuit Sword
- CM3
- Erik_gee's back button bracket and pcb
- Hooly Hoo's snes screen bracket with brass inserts
- Glass screen surround
- Rocker volume pot installed
- Dextech's 5000+mAh lipo battery
3D printed parts by shapeways:
- Hooly Hoos' CM3 Circuit Sword Fan Cartridge
- Hooly Hoo's Glue Less Support Bracket for Kite's Mode/Power Switch Board
DOES NOT INCLUDE MICRO SD CARD
Any questions just DM me.
Thanks
- Dark Grey DMG shell with light grey buttons
- Kites Circuit Sword
- CM3
- Erik_gee's back button bracket and pcb
- Hooly Hoo's snes screen bracket with brass inserts
- Glass screen surround
- Rocker volume pot installed
- Dextech's 5000+mAh lipo battery
3D printed parts by shapeways:
- Hooly Hoos' CM3 Circuit Sword Fan Cartridge
- Hooly Hoo's Glue Less Support Bracket for Kite's Mode/Power Switch Board
DOES NOT INCLUDE MICRO SD CARD
Any questions just DM me.
Thanks
- 01.jpg (1.86 MiB) Viewed 4192 times
- 02.jpg (1.92 MiB) Viewed 4192 times
- 03.jpg (880.35 KiB) Viewed 4192 times
- 04.jpg (1.13 MiB) Viewed 4192 times
- 05.jpg (913.7 KiB) Viewed 4192 times
- 06.jpg (1.65 MiB) Viewed 4192 times
- 07.jpg (892.81 KiB) Viewed 4192 times
- 08.jpg (1.18 MiB) Viewed 4192 times
- 09.jpg (1.82 MiB) Viewed 4192 times
- 10.jpg (2.08 MiB) Viewed 4192 times
- 11.jpg (2.13 MiB) Viewed 4192 times
- 12.jpg (1.84 MiB) Viewed 4192 times