Back Buttons Kite CS lite

[Rider]

Ok, so apologies if this has been asked already and again sorry for being a bit dim with this.
On the Kite CS lite board, does it matter which colour wire I use for the back buttons, using the plug supplied in the kit?

[kite]

As long as black is gnd (which can be confirmed by following the wire to the connector, which will have a labelled telling you the wire function) then order does not matter

[Rider]

As long as black is gnd (which can be confirmed by following the wire to the connector, which will have a labelled telling you the wire function) then order does not matter

Thanks, I was being an idiot. I’ve spotted the board even labels the L2R2 and ground.

[andershp]

Sorry to invade this topic, but I've seen build videos where users of only 2 back buttons tend to use the R2 and L2 wires to solder onto L1 and R1 back button sockets - why is this?

[kite]

Makes wiring a little simpler (less wires going to/from places)