Hi there
I got my board back from repair and its all working now well for the most part.
I have a odd issue that mario wont seem to jump as high as he should do ive tried using different conductive pads and even a bit of metal across the a button but mario just hasn't got it in him to jump his normal height.
No back board installed just abxy only.
Here is a clip of the prob.
https://www.youtube.com/watch?v=9t42nxpBSdE
Any suggestions.
button press issue
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: button press issue
Never seen that before, if you use a USB gamepad or something does that do the same? Have you tried other software? Does holding the button down (rather than just pressing) make it better or not?
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Re: button press issue
Thanks kite for the reply.
After doing what you said and testing voltages @ 3.270 across the board .......
It turns out that if you assign the hot key as button A, Then for some reason that makes the button act differently while still functioning in a limited way.
While this im sure is obvious to most people when assigning button configs i thought id share my stupid so others can benifit.
Ive assigned hot key as select button now.
Hope this post helps someone one day all the best.
After doing what you said and testing voltages @ 3.270 across the board .......
It turns out that if you assign the hot key as button A, Then for some reason that makes the button act differently while still functioning in a limited way.
While this im sure is obvious to most people when assigning button configs i thought id share my stupid so others can benifit.
Ive assigned hot key as select button now.
Hope this post helps someone one day all the best.
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: button press issue
Ah mystery solved! I typically "hold" the button when assigning hotkey to skip it, and it defaults it to SELECT anyway. There was a time when doing that would disable the select button, I have a feel that is fixed but I still always skip setting it and it defaults to SELECT.
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Who is online
Users browsing this forum: No registered users and 1 guest