Circuit Sword No Sound
Posted: Sat Sep 05, 2020 1:22 pm
I just completed my new Circuit Sword build and have no audio (speaker or headphones). I have a v1.3D board, using the volume wheel and 640x480 screen. Everything boots up fine and the test mode indicates everything is OK. I tried numerous settings in retro pie and settings files, and even re-downloaded the v1.3.3 image from github and started over just in case.
Using the volume control wheel I get a percentage change from 0-100 percent as I move it up and down. I have checked the mode button option to verify it is not muted and cycled mute on and off with no effect.
I checked the board and speaker and cannot find anything obvious. When I turn it on, I get a small pop like the amp is turning on and I get faint white noise from both the speaker and headphones, but no other sound.
Any help or suggestions would be appreciated.
Using the volume control wheel I get a percentage change from 0-100 percent as I move it up and down. I have checked the mode button option to verify it is not muted and cycled mute on and off with no effect.
I checked the board and speaker and cannot find anything obvious. When I turn it on, I get a small pop like the amp is turning on and I get faint white noise from both the speaker and headphones, but no other sound.
Any help or suggestions would be appreciated.