sudomod

Hi all -

Finally had some time and am ready to finish off this project! I have a SAIO 0.6 and things seem good except that the LCD and HDMI don’t display anything.

The HDMI sends a signal to the monitor, it is just black.

The LCD doesn’t display anything and I tried two so I don’t think it is the display.

Pics with lights on. The green PI light blinks a lot when I plug it in. The power switch doesn’t seem to do anything specifically so there is that.

Any ideas?

Thanks!

You’re plugging in to the raspberry pi, rather than the saio board. Plug the micro usb in to the saio board connector and the hdmi lead in to the saio breakout board (or connect the lcd screen).

Oh man - I was tired?

Thanks for the help!