Issue after Overscan

Post Reply
Retrobob
Posts: 17
Joined: Sun May 10, 2020 7:04 pm
Has thanked: 7 times

Issue after Overscan

Post by Retrobob » Wed Dec 09, 2020 10:17 pm

Good day!

I am working on the Circuit Sword, and used the Overscan to make it a more ideal fit. Issue is, after the 1st third of the screen (vertical split), the rest of the screen has horizontal distortion, and keeps flashing around. It only happens after it finishes start up, until I then shut it down.
1.jpg
1.jpg (72.5 KiB) Viewed 1908 times
2.jpg
2.jpg (72.26 KiB) Viewed 1908 times
3.jpg
3.jpg (71.78 KiB) Viewed 1908 times
These are the changes I made:

# Enable DPI
dtoverlay=dpi18
overscan_left=10
overscan_right=10
overscan_top=5
overscan_bottom=15
enable_dpi_lcd=1
display_default_lcd=1
dpi_group=2
dpi_mode=87

I went through several different values before I figured out what was ideal, and they all made the same issue. When I change the overscan back to 0, it resolves the issue, but then parts of the screen are hidden again. Any ideas?

Thanks!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest