Compute module bad?

Post Reply
joeleaux
Posts: 8
Joined: Fri Jun 07, 2019 6:28 am
Has thanked: 1 time

Compute module bad?

Post by joeleaux » Wed Aug 04, 2021 8:23 am

My build has stopped booting. When i plug in the board, it gets power and the LEDs all light up, but nothing happens on the screen. I enabled wifi via adding a wpa_supplicant.conf file to the boot section of the sd card. The board never connects to my wifi, any way to confirm this is the issue.

Thanks so much guys!

Anthology
Posts: 28
Joined: Tue Jun 30, 2020 1:05 pm
Has thanked: 2 times
Been thanked: 9 times

Re: Compute module bad?

Post by Anthology » Wed Aug 04, 2021 12:32 pm

Are you using the 320x or 640x version of the screen?

If you have the 640x version, check:
https://github.com/kiteretro/Circuit-Sw ... 40x480-lcd

joeleaux
Posts: 8
Joined: Fri Jun 07, 2019 6:28 am
Has thanked: 1 time

Re: Compute module bad?

Post by joeleaux » Thu Aug 05, 2021 7:30 pm

Well, i was using my 640x screen, but i swapped it out to the stock 320 screen (after undoing the config.txt steps to enable it) and it boots, so i may have a bad screen.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest