Circuit Shield - White Screen
Posted: Sun Jan 16, 2022 6:44 pm
Hi All,
Started getting my Circuit Shield together today, Ran through the set up here:
https://github.com/kiteretro/Circuit-Sh ... uit-Shield
Everything seems fine till step 11, where i don't get anything on my display, just white display (see Image 1).
Searching the forums it the only similar issues have either been with a badly seated CM3 or with solder on the SODIMM slot pins, neither seem to be my issue.(see image 3 and 5)
If I turn the device ON then OFF shortly after it stays on, but if i wait long enough before turning the device OFF it will turn off, would that mean its booting up enough to run the safe shutdown and that the screen is the issue? Im guessing not as it does seem to turn of immediately when it gets to that point.
The lights also change after being on for about 30 seconds(ACT becomes solid and FAN stops lighting up) See Image 2
Because of all the similar issues i could find relating to white screen being to do with the compute module, I'm guessing mine is to, unfortunately i don't think i have anything else to try the module in or another module to try in this.
Any suggestions on what i could do to work out what's wrong?
Started getting my Circuit Shield together today, Ran through the set up here:
https://github.com/kiteretro/Circuit-Sh ... uit-Shield
Everything seems fine till step 11, where i don't get anything on my display, just white display (see Image 1).
Searching the forums it the only similar issues have either been with a badly seated CM3 or with solder on the SODIMM slot pins, neither seem to be my issue.(see image 3 and 5)
If I turn the device ON then OFF shortly after it stays on, but if i wait long enough before turning the device OFF it will turn off, would that mean its booting up enough to run the safe shutdown and that the screen is the issue? Im guessing not as it does seem to turn of immediately when it gets to that point.
The lights also change after being on for about 30 seconds(ACT becomes solid and FAN stops lighting up) See Image 2
Image 1Show
Image 2Show
Image 3Show
Image 4Show
Image 5Show
Any suggestions on what i could do to work out what's wrong?