GPIO SHDN ON LCD Loop

Post Reply
Alienxdroid
Posts: 3
Joined: Sat Nov 27, 2021 7:11 am

GPIO SHDN ON LCD Loop

Post by Alienxdroid » Mon Feb 14, 2022 9:24 am

I’ve put together my Gem and have gotten to the point where the test loops the SHDN on and LCD Test forever.
I’ve tested the SHDN Gpio for continuity and it doesn’t look to have shorted to ground or any other pin around it. what’s the next step? Shouldn’t SHDN be set to off and when I turn the per switch to off it should have turned off, it didn’t it brought the menu up.
FD185BC9-C54E-4A58-B9D9-0C3B7EE81A93.jpeg
FD185BC9-C54E-4A58-B9D9-0C3B7EE81A93.jpeg (2.79 MiB) Viewed 593 times
0AB4D55B-7607-4142-A3CC-36B4A1F89F18.jpeg
0AB4D55B-7607-4142-A3CC-36B4A1F89F18.jpeg (2.52 MiB) Viewed 593 times

hicm3
Posts: 19
Joined: Sun Nov 14, 2021 4:26 am
Been thanked: 2 times

Re: GPIO SHDN ON LCD Loop

Post by hicm3 » Thu Feb 17, 2022 1:23 am

hi friend
do yiu modify the config cs txt file?
thx

Alienxdroid
Posts: 3
Joined: Sat Nov 27, 2021 7:11 am

Re: GPIO SHDN ON LCD Loop

Post by Alienxdroid » Sun Feb 20, 2022 3:06 pm

The only modification I made was to put it in test mode by setting #MODE=TESTER to MODE=TESTER. Thats when the loop happens. If I change it back it will stay stuck at the kiteretro screen and as far as I can tell never boot.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest