Please help someone
Please help someone
Giles this is the picture of the two broken solder pads on my board. They are directly on top of each other. I think they are called pin # 23 and 24. Please help me
- Attachments
-
- Broken solder pads
- 20180125_154851.jpg (3.95 MiB) Viewed 1992 times
-
- 20180125_154827.jpg (3.93 MiB) Viewed 1992 times
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: Please help someone
Hi,
Those solder blobs are too high, and you soldering iron is probably too hot and solder not good enough The bits of solder should be minimal to non-existent! By adding more solder and carefully moving it away, you can reduce the solder on there. See the video that I made on youtube here https://www.youtube.com/watch?v=Bqzf31Nla5c
Those two pins, are an element of BLUE and GREEN, however it WILL WORK without them.
EDIT: I will post where they lead to this evening
Those solder blobs are too high, and you soldering iron is probably too hot and solder not good enough The bits of solder should be minimal to non-existent! By adding more solder and carefully moving it away, you can reduce the solder on there. See the video that I made on youtube here https://www.youtube.com/watch?v=Bqzf31Nla5c
Those two pins, are an element of BLUE and GREEN, however it WILL WORK without them.
EDIT: I will post where they lead to this evening
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Who is online
Users browsing this forum: No registered users and 1 guest