sudomod

Giles this is the picture of the two broken solder pads on my board. They are directly on top of each other. I think they are called pin # 23 and 24. Please help me

Hi,

Those solder blobs are too high, and you soldering iron is probably too hot and solder not good enough The bits of solder should be minimal to non-existent! By adding more solder and carefully moving it away, you can reduce the solder on there. See the video that I made on youtube here https://www.youtube.com/watch?v=Bqzf31Nla5c

Those two pins, are an element of BLUE and GREEN, however it WILL WORK without them.

EDIT: I will post where they lead to this evening