Kite,
How deep from the surface are the tracings running? I've sliced up those channels pretty deep (I think), but not sure how to test if I've completely severed the connection. Are they just thin, surface tracings with almost no depth?
Kite,
Visually speaking, is the picture below correct on which points you are saying needs to be tested in Beep mode?
Went back and tested this and found a couple boards where the tracings were actually not severed fully, so this was a tremendous aid. You might want to add this testing instruction to the Digital Volume Control page on your github where you talk about trimming the tracings.markolomew wrote: ↑Thu Mar 01, 2018 7:37 amVisually speaking, is the picture below correct on which points you are saying needs to be tested in Beep mode?
Users browsing this forum: No registered users and 1 guest