Page 1 of 1

[Solved] Button 5 Not Working

Posted: Sat Mar 17, 2018 7:26 pm
by Mitaccio
I have 3 of the v0.6 that I made with just the four button config and everything was working fine. I am adding the shoulder buttons from eriK_gee and running into an issue. I have the buttons wired as usual with the supplied wire harnesses and am running into an issue with mapping. Every time I try to map the R button to button 5 I get nothing. I have tried swapping the wiring harness from L and R to see if it's a connection issue, but the problem is specifically mapping to button 5. I have no idea what I need to check/do next. Any help?

Re: Button 5 Not Working

Posted: Sun Mar 18, 2018 1:58 am
by kite
Picture of what you are connecting them to? You can use ANY of the L1/L2/R1/R2 ports, it doesn't matter about their name, as you map it in gui.. so just use another one

Re: Button 5 Not Working

Posted: Sun Mar 18, 2018 2:39 pm
by Mitaccio
I figured it out. I assumed that the wiring harness for the back buttons would use black as the ground, not the yellow.

Re: [Solved] Button 5 Not Working

Posted: Sun Jun 10, 2018 7:23 am
by jothie
Hurm, I'm having the same problem. Everything works but R1. I've desoldered and resoldered it with same results. Black is showing as ground to me not yellow. Maybe a mix up on some boards. If you used yellow as ground did you use black as button(or the red?)

Re: [Solved] Button 5 Not Working

Posted: Mon Jun 11, 2018 7:15 am
by kite
Show a picture of how you have it connected :) or planning to