sudomod

Hello,

Im finally starting my CSO build.
Since I have hardware version 1.1E I had to update the Arduino which I did on the pi directly.

How can I check now everything went well?
I got some error messages about OSD.

2nd Question.
Im using the 640x480 screen and would like to know if there is a theme that is optimized for it?

If already a thread exists please help me to point at it.

THX!

Errors about OSD are fine, when you do a reboot (should say in the instructions are an 'update.sh' to run 'reboot'

PS the 'update.sh' doesn't update the arduino, but updates the software on the SD card from the circuit sword git repo, there is another command to update the arduino firmware (instructions on github) : https://github.com/kiteretro/Circuit-Sw ... spberry-pi

Thats exactly what i followed step by step, so it should be fine I assume.

Yep sounds like you're good then! After a reboot if it all looks normal and works then it's great!