sudomod

Hey guys!
I am currently building my Gameboy Zero with a SAIO V 0.6C and i ran into a problem, while doing a test run.
I have tested the SAIO and the Pi Zero individually and both worked fine. I soldered it on using the tutorial and it seems like something went wrong. The Leds on the SAIO power up, but the USB hub is not, therefore i believe that is the reason, why the Pi Zero is not indicating that it is on. Can you see mistakes i did in the provided pictures? I tried soldering the ground similar to another guide, but that did not fix my problem.



SAIO when powererd on (USB indicator not on):

Try putting the SD into the Pi itself if it will fit and see if it boots. If it does, then it's the SD pads that need a little rework

That was our problem! We will fix this in the coming week and continue this great project. Thank you!