CM3 Rockerswitch not working

User avatar
kite
Posts: 950
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 242 times
Been thanked: 332 times
Contact:

Re: CM3 Rockerswitch not working

Post by kite » Thu May 09, 2019 6:04 am

This pin, can you rework this slightly?
rocker1.png
rocker1.png (67.12 KiB) Viewed 423 times
Another thing you can try, with it on, get a piece of wire with one end attached to like the USB port, and then touch the other end to one of those three contacts (in your picture, the three at the front). And see if there is a reaction on screen.

User avatar
phreaky
Posts: 68
Joined: Tue Nov 06, 2018 9:43 am
Has thanked: 22 times
Been thanked: 7 times

Re: CM3 Rockerswitch not working

Post by phreaky » Thu May 09, 2019 12:03 pm

kite wrote:
Thu May 09, 2019 6:04 am
This pin, can you rework this slightly?

rocker1.png

Another thing you can try, with it on, get a piece of wire with one end attached to like the USB port, and then touch the other end to one of those three contacts (in your picture, the three at the front). And see if there is a reaction on screen.
omg i didnt solder that pin.... *facepalm* sorry for wasting your time...

User avatar
kite
Posts: 950
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 242 times
Been thanked: 332 times
Contact:

Re: CM3 Rockerswitch not working

Post by kite » Mon May 13, 2019 2:29 am

Haha no problem :) i'm glad that it was something simple! It's not well documented (or even at all really) so don't worry about it! :D

There is also a pin on the opposite side, solder that too (its only purpose is to provide physical support for the switch)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest