Circuit Gem buttons problem!
Posted: Thu Jul 11, 2019 2:16 am
I am just an amateur in these raspberry pi programming. Yesterday I finished my own VMU gaming machine, but I was disappointed with those buttons. I would like to change those rubber buttons to pcb tactile switches.
For example, like that
https://www.distrelec.ch/en/tactile-swi ... p/13565645
Now I ask how to make these work in Circuit gem. I saw on your GPIO map ... there is BTN MODE - X, BTN SLEEP ZA, BTN A - ZF and U - BTN B. For example, if I put Tactile Switches to Mode, put one of the wire in that BTN MODE - X , but where I put the other wire.
Could you tell me this with the help of pictures ... make it easier to understand more.
I'm sorry for the bad English ... I hope you understand what I mean.
For example, like that
https://www.distrelec.ch/en/tactile-swi ... p/13565645
Now I ask how to make these work in Circuit gem. I saw on your GPIO map ... there is BTN MODE - X, BTN SLEEP ZA, BTN A - ZF and U - BTN B. For example, if I put Tactile Switches to Mode, put one of the wire in that BTN MODE - X , but where I put the other wire.
Could you tell me this with the help of pictures ... make it easier to understand more.
I'm sorry for the bad English ... I hope you understand what I mean.
