Page 1 of 1

Buttons fault Kite Circuit sword 1.3

Posted: Thu Oct 10, 2019 1:21 pm
by banjokazooie
All of sudden buttons presses by itself even after fresh sd image and no rubbers attached. Config of buttons in emulation station impossible. Any ideas what can be the reason for this?

Update: When configuring D-pad -> D-PAD UP enters by itself AXIS 0+ but no joystick is physically connected.

Re: Buttons fault Kite Circuit sword 1.3

Posted: Fri Oct 11, 2019 2:53 am
by kite
Can you try performing the arduino update, see how that goes: https://github.com/kiteretro/Circuit-Sw ... controller

Re: Buttons fault Kite Circuit sword 1.3

Posted: Fri Oct 11, 2019 4:41 am
by banjokazooie
Arduino flashed OK but issue still persist. When running python Circuit-Sword/cs-configure.py if JOY 1 is enabled refreshing the page shows movement on X with nothing connected. If disabled an only joy2 is on everything is ok. Any ideas?

Re: Buttons fault Kite Circuit sword 1.3

Posted: Fri Oct 11, 2019 8:57 am
by kite
Do you have any joys connected (or plan to)? If not then disable them

Re: Buttons fault Kite Circuit sword 1.3

Posted: Fri Oct 11, 2019 3:52 pm
by banjokazooie
kite wrote:
Fri Oct 11, 2019 8:57 am
Do you have any joys connected (or plan to)? If not then disable them
The plan was to use dual joystick, GB shell prepared. Is it a board/component fault ?

Re: Buttons fault Kite Circuit sword 1.3

Posted: Sat Oct 12, 2019 7:25 am
by kite
When the joysticks are plugged in, what do the readings of the analog values show? Are they wildly changing?

Re: Buttons fault Kite Circuit sword 1.3

Posted: Sat Oct 12, 2019 8:04 am
by banjokazooie
kite wrote:
Sat Oct 12, 2019 7:25 am
When the joysticks are plugged in, what do the readings of the analog values show? Are they wildly changing?
Only the 1st joy changes values by itself between 830 to 990 and if you keeps pressing enter to refresh eventually it jumps to ridiculous -30000 :o

Re: Buttons fault Kite Circuit sword 1.3

Posted: Sun Oct 13, 2019 4:01 am
by kite
Yeah something not really right there.. could you show pictures of how you wired up the joystick?