Printed probably one of the best controller mounts for Nintendo Switch

Show off your printer setup, amazing prints you've done, etc. here!
Post Reply
User avatar
DavGerm4
Posts: 2
Joined: Wed Jan 02, 2019 3:33 pm
Location: Vekta
Has thanked: 1 time
Been thanked: 1 time

Printed probably one of the best controller mounts for Nintendo Switch

Post by DavGerm4 » Sun Jan 06, 2019 11:06 pm

So I wanted to be able to use the Pro Controller for the Nintendo Switch, while in handheld mode. Instead of using the joy cons. I found this print on MyMiniFactory, was done by @JeremyDelisle. I will say it probably the only way I play the Switch now.Image
Image
Image
Image

There's a few changes that I'm going to have done, with the help of my friend that's good with 3D Design. And also make it lighter.

Took about 13 hours to print all of it, on a Zortrax M200
I 3D Print Stuff

User avatar
rodocop
Posts: 1641
Joined: Mon Aug 22, 2016 3:14 pm
Location: Saskatchewan
Has thanked: 596 times
Been thanked: 583 times

Re: Printed probably one of the best controller mounts for Nintendo Switch

Post by rodocop » Tue Feb 19, 2019 1:33 pm

Yeah, that is one of my favorite prints as well, I prefer the pro controller over the joy cons any day.
SpoilerShow
Image

louis_324
Posts: 1
Joined: Fri Nov 01, 2019 8:58 am

Re: Printed probably one of the best controller mounts for Nintendo Switch

Post by louis_324 » Fri Nov 01, 2019 9:01 am

No problem covering the intake for the fan?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest