From mistake to something cool

Show off your printer setup, amazing prints you've done, etc. here!
Post Reply
smoki86
Posts: 97
Joined: Sat Jul 30, 2016 7:45 am
Has thanked: 12 times
Been thanked: 47 times

From mistake to something cool

Post by smoki86 » Sun Feb 25, 2018 7:34 am

Hey there,

made a few holes too much, expanded it into a window and now added a printed cover on top.

Easier to show in pictures:
FuckupShow
gb5.jpg
gb5.jpg (78.46 KiB) Viewed 2430 times
Expanded into big "window" :
Saved it!Show
gbfin.jpg
gbfin.jpg (103.39 KiB) Viewed 2430 times
And covered with 3d printed part:
FinishedShow
3d.jpg
3d.jpg (90.11 KiB) Viewed 2430 times
The part, made in SketchUp:
PartShow
fan.png
fan.png (42.29 KiB) Viewed 2428 times

Double0EK
Posts: 70
Joined: Thu Dec 08, 2016 4:50 pm
Has thanked: 51 times
Been thanked: 8 times

Re: From mistake to something cool

Post by Double0EK » Fri Mar 02, 2018 5:29 pm

Nice save! Now if you can color match the 3D Part to the DMG Shell it would look like it was meant to be there.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest