Printed probably one of the best controller mounts for Nintendo Switch
Posted: Sun Jan 06, 2019 11:06 pm
So I wanted to be able to use the Pro Controller for the Nintendo Switch, while in handheld mode. Instead of using the joy cons. I found this print on MyMiniFactory, was done by @JeremyDelisle. I will say it probably the only way I play the Switch now.
There's a few changes that I'm going to have done, with the help of my friend that's good with 3D Design. And also make it lighter.
Took about 13 hours to print all of it, on a Zortrax M200
There's a few changes that I'm going to have done, with the help of my friend that's good with 3D Design. And also make it lighter.
Took about 13 hours to print all of it, on a Zortrax M200
