Making a hat for an M3D micro+

Show off your printer setup, amazing prints you've done, etc. here!
Post Reply
User avatar
Ampersand
Posts: 100
Joined: Fri Aug 04, 2017 3:52 am
Has thanked: 24 times
Been thanked: 126 times

Making a hat for an M3D micro+

Post by Ampersand » Mon Mar 04, 2019 3:19 pm

Not technically 3D printed but still in the same sphere.

I picked up the M3D micro+ because it doesn't take up much room and can sit in the corner ready when I need it. This is a filament holder that mounts it above the printer to keep the footprint small, it also holds a Raspberry Pi 3 with a touchscreen and octoprint + a camera that can be stored on the side.
SpoilerShow
IMG_7253 - Copy.JPG
IMG_7253 - Copy.JPG (1.21 MiB) Viewed 4788 times
IMG_7257 - Copy.JPG
IMG_7257 - Copy.JPG (1.05 MiB) Viewed 4788 times
IMG_7258 - Copy.JPG
IMG_7258 - Copy.JPG (1.03 MiB) Viewed 4788 times
IMG_7259 - Copy.JPG
IMG_7259 - Copy.JPG (952.45 KiB) Viewed 4788 times
IMG_7248 - Copy.JPG
IMG_7248 - Copy.JPG (1.34 MiB) Viewed 4788 times
I messed up and blocked the USB ports on the Pi so that needs a small redesign, and I need to print off some end caps for the copper pipe.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest