Circuit Shield EXT/USB-C cutout

Share your STL files, CAD design files, etc. here!
Post Reply
millski
Posts: 49
Joined: Tue Jul 18, 2017 5:07 am
Has thanked: 12 times
Been thanked: 17 times

Circuit Shield EXT/USB-C cutout

Post by millski » Mon Jul 20, 2020 2:07 am

I didn’t like the big gap below the USB-C connector inside the EXT opening on the Circuit Shield, so I made a piece to fit in there.

Tolerance is very tight (I used uhb tape instead of glue and had to sand the part a little to allow for the tape thickness). Test fit before sticking it in!

Open cutout:
Image
Part:
Image
Fitted:
Image
usbc cutout gbp2.stl
(51.94 KiB) Downloaded 28 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest