Circuit Shield EXT/USB-C cutout
Posted: Mon Jul 20, 2020 2:07 am
I didn’t like the big gap below the USB-C connector inside the EXT opening on the Circuit Shield, so I made a piece to fit in there.
Tolerance is very tight (I used uhb tape instead of glue and had to sand the part a little to allow for the tape thickness). Test fit before sticking it in!
Open cutout:
Part:
Fitted:
Tolerance is very tight (I used uhb tape instead of glue and had to sand the part a little to allow for the tape thickness). Test fit before sticking it in!
Open cutout:
Part:
Fitted: